Bull DPS7000/XTANOVASCALE 7000 180Rb 7, Service Manual, Page: 55 / 258

Setting Up the System 2-19
Connecting the Power Cord
Plug the female end of the AC power cord into the input receptacle on the rear
of the server chassis (see Figure 2-19). Plug the male end of the power cord into
a NEMA 5-15R outlet for 100-120VAC or a NEMA 6-15R outlet for
200-240 VAC or optional UPS.
If the power cord supplied with the system is not compatible with the AC wall
outlet in your region, obtain a suitable power cord that meets the following
criteria.
!
The power cord must be rated for the available AC voltage and have a
current rating that is at least 125% of the current rating of the system.
!
The power cord connector that plugs into the wall outlet must be
terminated in a grounding-type male plug designed for use in your region.
It must have certification marks showing certification by an agency
acceptable in your region.
!
The power cord must be less than 2.7 meters (9.0 feet) long.
After the power cord is plugged in confirm that the power status lamp on the
power unit flashes. If the lamp is off, a failure occurred in the power unit, see
Table 1-3 System Status LED Indicators in Chapter 1 of this User's Guide.
When connecting the power cord to a power control unit, such as an UPS
confirm that the power control unit is powered off. Connecting the power cord
while power is supplied to the power control unit may cause a failure.
! WARNING
Your system shipped with a power cord for its AC power. Do
not attempt to modify or use the supplied AC power cord if it
is not the exact type required.
Figure 2-19. Connecting the AC Power Cord to the DEU