Bull DPS7000/XTANOVASCALE 7000 180Rb 7, Service Manual

Page: 140 / 258

4-30 Disassembly and Reassembly
Eject/insert levers are provided with your system for easy removal of a
processor cartridge or a termination board (see Figure 4-17) from your
system. Install the levers on the upper right and left corners of the processor
cartridge or termination board. Make sure that you fit the pin of each latch
into the top corner hole of the processor cartridge or termination board so
that the levers face each other. Then to remove a processor cartridge or
termination board push both the left and right eject/insert levers to an outside
position, which in turn lifts the a processor cartridge or termination board in
an upward motion out of its socket.
6. Grasp the cartridge by the eject/insert levers, (A) and carefully slide it into
the slot guides of the processor retention bracket until the processor stops.
See Figure 4-17.
7.
To seat the cartridge in the mezzanine board connector, push down on the
levers simultaneously, making sure that the lever locks (B) engage with the
slots of the processor retention bracket flange (C).
8. Insert the hook end of the holddown bracket in the flange of the processor
retention bracket. See Figure 4-16.
9. Reinstall the holddown securing screw.
10. Reinstall the top cover.