Bull DPS7000/XTANOVASCALE 7000 180Rb 7, Service Manual

Page: 47 / 258

Setting Up the System 2-11
1.
Remove the power supply located on the rear of the server directly under the
AC input power connector. Refer to “Removing a Power Supply” in
chapter 4.
2. Attach arm bracket 1 (see Figure 2-7, A) by placing it over the three screw
posts that protrude out on the inside edge of the chassis facing the power
supplies.
A
Figure 2-7. Attaching Arm Bracket 1 to the Rear of Server
3. Using three 6-32 screws secure arm bracket 2 (see Figure 2-8, A) to the
outside edge of arm bracket 1 just installed on the rear of the server. The rear
edge of the metal cabinet should now be sandwiched in between Arm
Bracket 1 (A) and Arm Bracket 2 (B)providing extra structural strength (see
Figure 2-9).
A
Figure 2-8. Attaching Arm Bracket 2