146
Cartridgex I36
Decryption error
Media cartridge cannot be decrypted.
The media cartridge may have been
encrypted by a TeraStation other than
this product.
Connect to the TeraStation that performed
encryption to decrypt.
Recovery I37
SystemRecovering
System recovery in progress.
-
Recovery I38
RecoveryFinished
System recovery is complete.
-
Recovery I39
Change Boot
System recovery from the USB
recovery device is complete.
Change the boot mode switch on the rear to HDD.
Recovery I40
DataWillDeleted
Beginning recovery. All data on the
drive in Disk 1 will be deleted.
-
Recovery I41
PushFuncToStart
Pressing the Function button on the
front will start the recovery process.
-
Recovery I42
Preparing
Preparing to start the recovery
process.
-
Recovery I43
Unsupported HW
The TeraStation was started from the
USB recovery device, but the system
cannot be recovered from this USB
recovery device.
-
Recovery I44
Disk1 not found
Recovery from the USB recovery
device was initiated, but Disk 1 was
not detected.
Make sure that Disk 1 is present and fully inserted in
its slot.
Recovery I45
Recovery Failed
Recovery failed.
-
RAID ARRAY I46
RMM+Processing
Data migration or conversion (RAID
migration) is in progress.
Do not turn off the TeraStation power.
SYSTEM I47
Don’t Power Off
FailOver I48
PushFuncToStart
This TeraStation is ready to become
the failover backup for the main
TeraStation.
Hold down the Function button on the front of the
target TeraStation until it stops beeping to accept
failover backup status.
FailOver I49
LostMainTarget
The main TeraStation in the failover
configuration cannot be found.
Make sure that the main TeraStation is on, working,
and connected to the network.
FailOver I50
Maintenance mode
Failover maintenance is in progress.
Do not turn off the TeraStation power.
FailOver I51
Initializing
Initializing the failover configuration.
Do not turn off the TeraStation power.
New Firmware I52
Available
A new firmware version has been
released.
Update the firmware.
BackupTask xx I54
Backup Failure
xxth backup task has been failed.
Make sure xxth backup task is configured correctly.
(“xx” is backup task number.) The LinkStation or
TeraStation may be in standby mode. Start the NAS
on. If the backup task still fails, check the status of
NAS, network, and backup source or destinations.
Summary of Contents for TeraStation TS4200D
