9
Select the backup destination and click
OK
.
10
Click
OK
. Jobs added to "Backup List" are displayed.
11
Click
Close
.
Replication
Replication copies all data from a share to a share on a different TeraStation. This is an easy way to configure a
reliable system to provide data protection in the event your main TeraStation fails. To configure replication, connect
an Ethernet cable to the LAN port of each TeraStation and follow the steps below.
Notes:
• For best results, use static IP addresses for both replication TeraStations (source and destination). These IP
addresses should be the same network segment.
• Replication source data is copied to the replication destination folder with a differential overwrite. Any data that
is not in the replication source will be overwritten.
Preparing a Replication Destination
First, configure a folder as a replication destination.
1
In Settings, click
File Sharing
.
2
Click
to the right of "Folder Setup".
67
Summary of Contents for TeraStation 1000
