Buell XB 2008 Series, Service Manual

Page: 477 / 688

2. Install turn signal using lockwasher and jam nut. Tighten
fastener to 25-28 in-lbs (2.8-3.2 Nm).
3. Attach bullet connectors on turn signal wires as shown in
Figure 7-45 .
4. Check turn signals for proper operation. If operation fails,
reread procedure and verify that all steps were performed.
a. Turn ignition key switch to ON.
b. Activate left turn signals using switch on left
handlebar. Front and rear left turn signals must flash.
c. Activate right turn signals using switch on left
handlebar. Front and rear right turn signals must flash.
d. Turn ignition key switch to OFF.
5. Install windscreen. See 2.50 WINDSHIELD AND WIND-
SCREEN: LIGHTNING AND ULYSSES .
1
2
3
3
2
1
4
sm03810
1. Turn signal
2. Jam nut and lockwasher
3. Front module, left and right
4. Windscreen
Figure 7-47. Front Turn Signals: Lightning
ULYSSES
Removal
1. Remove windshield and windscreen. See 2.50 WIND-
SHIELD AND WINDSCREEN: LIGHTNING AND
ULYSSES
.
2. See Figure 7-45 . Disconnect bullet connectors on turn
signal wires.
3. See Figure 7-48 . Remove jam nut and lockwasher (2) from
inside of front module (3).
4. Pull bullet connectors and wiring through hole in front
module (3) and remove turn signal (1).
Installation
1. See Figure 7-48 . Insert bullet connectors and wiring
through hole in front module.
2. Install turn signal using lockwasher and jam nut. Tighten
fastener to 25-28 in-lbs (2.8-3.2 Nm).
3. Attach bullet connectors on turn signal wires as shown in
Figure 7-45 .
Be sure that all lights and switches operate properly before
operating motorcycle. Low visibility of rider can result in
death or serious injury. (00316a)
4. Check turn signals for proper operation. If operation fails,
reread procedure and verify that all steps were performed.
a. Turn ignition key switch to ON.
b. Activate left turn signals using switch on left
handlebar. Front and rear left turn signals must flash.
c. Activate right turn signals using switch on left
handlebar. Front and rear right turn signals must flash.
d. Turn ignition key switch to OFF.
5. Install windscreen and windshield. See 2.50 WINDSHIELD
AND WINDSCREEN: LIGHTNING AND ULYSSES .
2008 XB Service: Electrical 7-33