Operating the Logamatic BC10 base controller
9
Logano GB125 oil condensing boiler - Technical specifications are subject to change without prior notice.
46
The following status displays can be shown, subject to the respective operating
mode:
Display
(examples)
Value range
Explanation
Operating state/remedy
1
Figure 0... 100
Current boiler water temperature
Standard operating state
Maintenance interval in accordance with
hours run or a date has been activated
Operating message:
Current EMS state
1
H00 ... H99
Warning: Service required
Service message (maintenance mes-
sage)
Meaning of the service code (see docu-
mentation "Service guideline for boilers
with digital burner control unit SAFe").
Operating message:
Current EMS state
Figure 0... 100
Current boiler water temperature
Service code
Fault
B
When the display flashes (disabling
fault), press the "Reset" button to reset
the fault.
B
If the display is not flashing (blocking
fault), the fault will be reset automatically
when its cause has been removed.
Figure > 200
Fault code
Figure 0... 100
Current boiler water temperature
1
A00 ... A99
Service code
System fault
System faults are heating system faults
which will not impair the burner operation.
Figure > 800
Fault code
Operating message:
Current EMS state
Figure 0... 100
Current boiler water temperature
Maintenance interval in accordance with
hours run or a date has been activated
(flashing)
Fault
No communication between BC10 and the
burner control unit.
Fault
B
Check the connections on both devices.
B
Check the communications cable.
Tab. 24 Possible status displays
1
Standard display for this operating state. This display is shown after 5 minutes if no keys are pressed.
60
HAH
-H
H 8
-H
60
7P
549
60
A12
816
-H
60
HAH
-
