Page 41
IMPORTANT SAFEGUARDS
Although your gas logs are very realistic in appearance, it is not a real burning fireplace and must
not be used for burning solid fuel.
To avoid irreparable damage to the heater or personal injury, matches, paper, garbage, or any
other material must not be placed or thrown on top of the logs or into the flames.
To avoid personal injury, do not touch hot surfaces when the heater is operating. Close
supervision is necessary when the heater is being operated near children.
NOTE: An annual examination and cleaning of the venting system of the solid-fuel burning
fireplace, must be done by a qualified agency.
WARNING:
ALL THE LOGS ARE MANUFACTURED FROM BONDED
CERAMIC FIBER. THIS IS A COMMONLY USED MATERIAL IN INDUSTRY
WORLDWIDE. IN THE EVENT OF THE LOG BEING REMOVED, CARE SHOULD BE
TAKEN TO NOT DAMAGE THE BONDED MATERIAL.
INTENTIONAL MISUSE OR DELIBERATELY FRAGMENTING THE MATERIAL COULD
LEAD TO INHALING FIBERS AND BE INJURIOUS TO YOUR HEALTH.
THE HEATER IS NTENDED FOR USE AS A GAS HEATER MOUNTED IN AVENTED OR
VENT-FREE FIREPLACE AS DESCRIBED IN THESE INSTRUCTIONS. IT SHOULD NOT
BE USED FOR ANY OTHER PURPOSE.
CLEANING
CAUTION:
BEFORE CLEANING OR MOVING LOGS OR OTHER PARTS OF THE
HEATER, BE SURE TO READ THE ABOVE SECTION
ON “IMPORTANT SAFEGUARDS”
.
All cleaning should be carried out when the heater is cold. Only limited cleaning will be required
under normal use. Dusting the front of the base, the top of the piezo cover, or the control knob
panel may be required occasionally. Do not use any cleaning fluids to clean the logs or any
other part of the heater.
If the flames show any unusual shapes or behavior, or if the burners fail to ignite properly, then
the burner holes may require cleaning. If this occurs, it is preferable to contact your nearest
dealer to get your heater serviced.
Alternatively, the heater can be cleaned by removing the top, front, and rear logs. Handle the logs
gently so as not to damage the fiber pieces. Always lift each log by holding it carefully at each
end. Use a vacuum cleaner to carefully remove dust and loose particles from the base, logs, and
from around the burners. Gloves are recommended to prevent the fibers from breaking your skin.
If the skin is broken, wash gently with soap and water.
WARNING: Failure to keep the primary air opening(s) of the burner(s) clean mat result in
sooting and property damage.
Summary of Contents for CR18
Page 2: ......
Page 50: ...Page 48 Figure 12 SIT MILLIVOLT VALVE 18 24 BASE...
