Page 10
CR18 LOG SET
(WITH DX18MV LOG BASE)
Open the cartons containing the Burner Base and the logs. Inside one of the cartons you will find the Burner Base. The logs are
boxed separately.
CR18: 1) Rear Log, 2) Ember strip, 3) Front log, 4) Top Log.
WARNING:
POSITIONING OF LOGS IS VERY CRITICAL. (See Figure 5.)
LOG PLACEMENT FOR CR18 LOG SETS:
1) Place rear log #1 on rear log support. The log has two alignment notches on back.
2) Place ember strip #2 on front bottom andirons. Center from side to side.
3) Next place front log #3 between rear and front burner tubes on the log supports for proper alignment.
4) Left top log #4 has two holes provided to fit over the pins in the front log to insure proper fit.
1
3
2
4
Figure 5
WARNING:
Failure to position the
parts in accordance with these diagrams
or failure to use only parts specifically
approved with this heater may result in
property damage or personal injury.
Summary of Contents for CR18
Page 2: ......
Page 50: ...Page 48 Figure 12 SIT MILLIVOLT VALVE 18 24 BASE...
