KTF/100HPS Operation
- 3-12 -
KTF/100HPS
P2 Programming Level
LFA m/min
#
ADVANCED
#
MENU P2
The P2 programming level allows you to setup 3 parameters:
1)
Device tension with machine stationary;
2)
Yarn relaxation tension;
3)
Yarn feeding speed at which the relaxation tension shall be activated.
to select the P2 level.
to continue with programming of P2 menu parameters.
P2.1
EXIT TENSION
Tension value of KTF device when the machine is stationary or out of yarn
working zone
(INC/DEC pulses deactivated).
By setting a value higher or lower
than the value set with
MAIN TENSION
parameter of P1 menu, you can control the
deceleration phase of KTF/100HPS device.
This function may be either enabled
(with values ranging from 0.2 to 100.0 grams)
or disabled
(OFF)
. To disable the function press and hold down for 3 seconds the
Enter button.
The
OFF
indication means that the function has been disabled. In this case the
EXIT
TENSION
parameter will assume the same value set on
MAIN TENSION
parameter
within the P1 programming level.
To re-enable this function press and hold down for 3 seconds the Enter button. The
OFF
indication will disappear and it will be replaced by a modifiable numeric
value. Choose the desired value using:
(to increase the value)
or
(to decrease the value).
to confirm.
P2.2
RELAX TENSION
Yarn relaxation tension. This function allows to relax the yarn tension to the
programmed value, every time the KTF/100HPS stops working. See the next
function
(
RELAX SPEED
)
. This function is activated in a way which is tightly related
to the “
MODE
” function selected within the P3 programming level.
!
MODE
00
#
the function is active when the KTF/100HPS stops working,
with INC/DEC commands active.
!
MODE
01
#
the function is active when the KTF/100HPS stops working,
during the graduation reset phase.
!
MODE
02/03
#
the function is active when the KTF/100HPS stops working.
!
MODE
04
#
this parameter is not significant.
