July 2013 © British Telecommunications plc 2013
Page 13
Figure 11 - wiring to an alarm panel that supports single / dual path identification
Output 2
Output 2 normally acts as a control output. This can be switched on and off by issuing the
relevant telemetry command from the ARC.
Telemetry request ID=0, Data=01 sets GPOP2 to low. ID=1, Data=01 sets GPOP2 high.
Output 2 can also become a secondary path fail output if F8 is set to 4.
In this case output 1 behaves as a primary path fail output, and output 2 as a secondary path
fail output.
Output 1 and 2 also support galaxy mode. See galaxy mode section.