Brother TD-4000, Service Manual

Page: 94 / 139

III - 69
[ 9 ] Reassembling the Roll Guide
(1) Assemble the roll guide spring B onto the roll guide shaft.
(2) Assemble the roll guide shaft into the positioning hole of the roll guide, and slide
the roll guide shaft to the direction of the arrow. Align the three groove parts of
the roll guide shaft with the three ribs of the roll guide to assemble the roll guide
shaft to the roll guide.
(3) Assemble the roll guide spring A onto the roll guide actuator.
(4) Align the two pins of the roll guide actuator with the positioning hole of the roll
guide to assemble the roll guide actuator to the roll guide.
NOTE1: Confirm that the roll guide spring A align with the positioning groove of the
roll guide spring A.
NOTE2: Confirm that the section "A" of the roll guide actuator is the inside of the rib
of the roll guide.
Figure 3.5-47 Reassembling the Roll Guide (1)
Positioning hole
of roll guide shaft
Positioning hole
of roll guide
Roll guide
Ribs
Groove parts
Roll guide shaft
Roll guide shaft
Positioning groove
of roll guide spring A
Roll guide spring A
Section "A"
Rib
Roll guide spring B
Roll guide actuator
Pins