Troubleshooting
201
25
Indicator Warnings
25
Problem
Solution
Received data in buffer
Print data is saved in the buffer. If the P-touch labeling system has
not received the complete data, printing will not start.
Turn off the P-touch labeling system, and then turn it on again.
Head is cooling down
The thermal head is too hot.
The P-touch labeling system stops and resumes printing only after
the thermal head has cooled down. The head may become too hot
if you are printing a large number of labels.
When the thermal head becomes too hot, it may produce imaging
on the labels in areas not intended to be printed. To avoid or delay
overheating, make sure the P-touch labeling system has adequate
ventilation and is not located in an enclosed space.
If the P-touch labeling system must cool down because it
overheated due to the type of Tape Cassette you are using or the
contents of the label, printing may take longer than usual.
Note
This condition may occur more often when the P-touch labeling
system is used at high altitude (more than 10,000 ft (3,048 m))
due to a lower air density available to cool the P-touch labeling
system.
P-touch labeling system is in boot mode
To resolve the issue, contact your Brother dealer or Brother
customer service for assistance.
Errors concerning tape cassettes
Check the following:
You are using the correct Tape Cassette.
There is enough tape remaining.
The Tape Cassette is installed correctly.
I want to reset an error
I want to reset an error
1 Open the Top Cover, and then close it.
2 If the error is not reset, press the
(Feed and Cut) Button.
3 If the error still is not reset, turn off the P-touch labeling system,
and then turn it on again.
4 If the error still is not reset, contact Brother customer service.
Summary of Contents for P-touch PT-D800W
Page 244: ......
