Brother P-touch PT-3600, Service Manual

Page: 97 / 165

III-63
2.5. Half Cutter Adjustment Mode ( “ 5 ” key )
This mode checks the half cut function.
Fig. 14
(1) Press the “RET” key. The display shifts to one as shown in Fig.15.
Fig. 15
(2) Press the “1” key. The display shifts to the Print Mode 1 that enables to set and print
the sample print to examine the cutter blade length.
(3) Press the numeric keys to enter the cutting range and step length.
(4) The entered value is fixed by pressing the “RET” key and then the sample printing is
started. After the completion of printing, the display returns to the initial display of the
setting-item selection.
Note 1: Press only the “RET” key to start the sample printing, if you accept the default
setting values.
Note 2: To determine the sample print quality, set the feed length of the tape to 30 mm
and reduce the step length from 200 to 160 by 5 steps. The acceptable print
quality should be one to be hardly observed a tiny cutting scar at step 200. See
the print sample shown in Fig.16. The half cut should be located below the
numerical figure.
(Example: Step 200 through step 160)
Fig. 16