Brother P-touch PT-3600, Service Manual

Page: 109 / 165

III-75
(4) Press the “RET” key. The machine writes the entered correction value described
above into the EEPROM and displays as shown in Fig.52.
Fig. 52
(5) Press the “RET” key while the LCD displays as shown in Fig.52. The display shifts to
the RS I/F Port Check Mode as shown in Fig.53.
Note: Press the “9” key before shifting to the Margin Set Mode. The display shifts to
the Avery Print Mode. Check again the start position of printing area of the
sample print.
2.16. Margin Set Mode ( “ R ” key )
This mode adjusts the margin cut length.
Note 1: You may skip this mode if the print sample by the Print Mode 1 gets into the specified
zone.
Fig. 53
(1) Press the “RET” key. The display shifts to one as shown in Fig.54.
Fig. 54
(2) Press the “1” key and set the number of counter rotation pulses at the margin cut
process (10 through 150 pulses).
Note 2: The number of counter rotation pulses is the number of counter rotation pulses
after the print operation.
(3) Press the “2” key and set the number of superimposed dots at the margin cut process
(0 through 3 dots).
Note 3: The number of superimposed dots is the number of the superimposed dots
required at the normal rotation after the counter rotation.
(4) Press the “3” key and set the number of offset pulses at the margin cut process (-4
t4 pulses).
Note 4: The number of offset pulses is the number of offset pulses to adjust the print
start position at the margin cut process.