Brother P-touch PRO DX PT-9200DX, Service Manual

Page: 64 / 104

II-51
[
14]
Error Message
A list of error messages related to PT-9200DX is shown below.
The language monitor displays the error message and the countermeasure.
Error Message Displayed on Monitor Countermeasure Displayed on Monitor
(User Takes an Action Referring to This.)
No Errors. There is no advice.
Cassette not installed. After installing the correct cassette, click the
Resume button in the P-touch Monitor.
(Caution)
Install the tape cassette specified in the
P-touch Monitor into the P-touch.
End of tape. Install a new tape cassette into the P-touch,
then click the Resume button in the P-touch
Monitor.
Buffer full error in the P-touch. Turn off the P-touch and turn it back on.
Then click the Resume button.
P-touch tape cutter not operating. After removing the jammed tape, try printing
again.
(Caution)
Before removing the jammed tape, be sure to
turn off the machine's power and disconnect
its power supply cable.
Be careful that you do not cut your fingers on
the tape cutter.
Cannot change cassette while printing. Turn off the P-touch and turn it back on.
Then click the Resume button.
Appropriate cassette not installed. After installing the correct cassette, click the
Resume button in the P-touch Monitor.
(Caution)
Install the cassette specified in the P-touch
Monitor into the P-touch.
P-touch may have invalid data in
memory. Turn off the P-touch and turn it back on.
Battery weak. Replace batteries with new ones or use the
power cable.
(Caution)
This is not displayed if the battery is so weak
that power supply to the P-touch is not turned
on.
Cover open. Close the cover.
Connected P-touch is not PT-9200DX. Connect the correct P-touch.
End of tape cannot be found. Check that the tape is not caught on anything.