Brother P-touch PRO DX PT-9200DX, Service Manual

Page: 45 / 104

II - 32
[3] Reassembly of the Half Frame Assy
(1) With the holes in the frame set on the bosses on the half frame assy,
tighten the two screws from the half frame side.
Fig. 2.2-39 Reassembly of the Half Frame Assy
(2) After applying the specified grease (2 mm
3
) on the end of the motor worm
gear, insert the full cutter motor assy into the square hole in the half frame
assy from the back then insert the end of the motor worm gear into the
small hole in the half frame. After that tighten the two screws with the end
of the motor worm gear pressed downward. (Specified grease: Silicone
grease G501)
(3) Insert the half cutter motor assy from the back of the half frame assy, and
tighten the two screws. Then, apply the specified grease (3 mm
3
) on the
gear of the half cutter motor assy. (Specified grease: Silicone grease
G501)
Backlash on the motor gear should be 0.05 to 0.3 mm.
Fig. 2.2-40 Reassembly of the Half Cutter Motor Assy and the Full Cutter Motor Assy
Boss on the half frame
Boss on the half frame
Half frame assy
Two screws
Main frame
Half cutter motor assy
Apply the grease here.
Two screws
Half frame assy
Full cutter motor assy
Two screws
Apply the grease here.