Brother P-touch PRO DX PT-9200DX, Service Manual

Page: 65 / 104

II-52
Error Message Displayed on Monitor Countermeasure Displayed on Monitor
(User Takes an Action Referring to This.)
Wrong AC adapter connected. Use the AC adapter designed exclusively for
this unit.
Communication error between PC and
P-touch. Check for the following.
Communication error in the P-touch. Start up the Change Baud Rate Wizard.
However, the current job should be deleted
before starting it up.
Transmission settings incorrect. A communication error occurs within the
P-touch due to an over-run error, a
communication buffer full error, etc.
Not enough memory to print document. Try again after the other application is
finished.
Not enough disk space to spool
document. Make sure that there is enough free space on
the disk.
Invalid port was specified. Select a valid COM port using the Control
Panel and Resume.
Port being used for another application. Try again after the other application is
finished.
(Caution)
If this error occurs, check for the following.
- Is a mail application which uses the same
port as the P-touch not running?
- Is transmission software that uses the same
port as the P-touch not being used
immediately before?
- Is the same port selected by more than one
P-touch units?
Error of unknown cause occurred. Unexpected error occurred. Make a copy of
the Fault Report sheet, fill in the necessary
information, and then fax it to your service
representative.