Brother P-touch PRO DX PT-9200DX, Service Manual

Page: 49 / 104

II-36
(4) Turn the body cover over, and set the cut feed button on the projection
and hole “B” in the body cover.
(5) Insert the projection on the power supply switch button into the guide of
the power supply actuator. With the three projections set, set this button
on the projection and hole “A” in the body cover.
(6) Set the hole and the slit of the sub PCB assy on the projections of the
body cover, and tighten the two screws. At this time, check if the solder of
the harness has peeled off.
Fig. 2.2-46 Reassembly of the Button and the Sub PCB Assy
(7) Set the sensor PCB assy on the two hooks of the body cover and press
the sensor PCB until these hooks click. (There is no screw to be
tightened.) Check if the solder of the harness has peeled off.
(8) Insert the tape end sensor assy into the square hole in the body cover,
and tighten the two screws.
Insert the tape end sensor harness into the groove in the body cover.
Fig. 2.2-47 Reassembly of the Sensor PCB Assy and the Tape End Sensor Assy
Two screws
Body cover
Tape end sensor assy
Groove in the body cover
Hook
Sensor PCB assy
Hook
Two screws
Power supply switch button
(ON/OFF key)
Power supply actuator
Cut feed button (FEED/CUT key)
Hole “A”
Hole “B”
Projection
Projection
Body cover
Projections
Sub PCB assy
Hole
Slit