CHAPTER 8 SOFTWARE SERVICE SUPPORT
Confidential
8-2
< Functions of each “User Mode” >
(1)
Test Sample Page
The printer prints a demo page. The printer returns to the ready status after printing.
(2) Print
Fonts
The printer prints a list of the internal fonts. The printer returns to the ready status after
printing.
(3)
Hex Dump Mode
You can print data as hexadecimal code. To exit from this mode, you have to turn off the
printer.
(4)
PCB ONLY Mode
Even when the engine error occurs and PCB exchange is required for recovery, the
printer can be started, ignoring the engine error if this mode is used. NVRAM data can be
obtained.
(5)
1push Printing Recovery Mode
Demo page print is possible by pressing
Go
button after the power supply is turned on.
The data for printing is cleared since the mode can be executed only once.
This mode enables to recover demo page printing. However, the design of printing is not
demo page printing, but test printing.
(6)
Network Factory Reset 1 (APIPA: ON)
The network setting is reset to its factory setting. (APIPA is ON) Refer to
Section 6.2 of
Chapter 2.
(7)
Network Factory Reset 2 (APIPA: OFF)
The network setting is reset to its factory setting. (APIPA is OFF) Refer to
Section 6.3 of
Chapter 2.
(8)
NV-RAM Factory Reset
The printer is restored to the factory setting and permanent fonts and macros are cleared.
The printer returns to the ready status after printing.
