Brother DCP-J925DW, Service Manual

Page: 62 / 378

2-17 Confidential
*1 Available in German models only.
*2 Establishment of FAX communication
FAX communication is established when the calling station receives a DIS (reception capability) signal
from the called station and the called station receives an NSS or DCS (communications test) signal from
the calling station.
Code 1 Code 2 Cause Refer to:
A0 03 Error correction sequence not terminated even at the
final transmission speed for fallback.
Chapter 2, Section
4.9.4
A0 11 Receive buffer empty. (5-second timeout)
A0 12 Receive buffer full during operation except receiving
into memory.
A0 13 Decoding error continued on 500 lines or more.
A0 14 Decoding error continued for 15 seconds or more.
A0 15 Timeout: 13 seconds or more for one-line
transmission.
A0 16 RTC not found or carrier OFF signal detected for 6
seconds.
A0 17 RTC found but no command detected for 60 seconds
or more.
A0 19 No image data to be sent.
A8 01 RTN, PIN or ERR received at the calling terminal.
*1
A9 01 RTN, PIN or ERR received at the called terminal.
*1
AA 18 Receive buffer full during receiving into memory.
B0 02 Unable to receive the next-page data.
B0 03 Unable to receive polling even during turn-around
transmission due to call reservation.
B0 04 PC interface error.
BF 01 Communication canceled by pressing the Stop/Exit
key before establishment of FAX communication
*2
.
BF 02 Communication canceled by pressing the Stop/Exit
key after establishment of FAX communication
*2
.
BF 03 Transmission canceled due to a scanning error caused
by no document or document feed problem in ADF
scanning in real time transmission.