24
For Wireless Network Users
10
One-push setup using
WPS or AOSS™
(Windows
®
& Macintosh)
a
Confirm your wireless access point/router has
the WPS or AOSS™ symbol as shown below.
b
Place the Brother machine within range of your
WPS or AOSS™ access point/router. The
range may differ depending on your
environment. Refer to the instructions provided
with your access point/router.
c
Press .
Swipe up or down, or press
a
or
b
to display
Network
, and then press
Network
.
Swipe up or down, or press
a
or
b
to display
WLAN
, and then press
WLAN
.
Swipe up or down, or press
a
or
b
to display
WPS/AOSS
, and then press
WPS/AOSS
.
When
Enable WLAN?
is displayed, press
Yes
to accept.
d
When the LCD shows to start WPS or AOSS™,
press the WPS or AOSS™ button on your
wireless access point/router. See the user’s
guide of your wireless access point/router for
instructions.
Then press
OK
and your machine will now
automatically detect which mode (WPS or
AOSS™) your wireless access point/router
uses and try to connect to your wireless
network.
e
A connection result message appears until the
OK
button is pressed on the LCD.
If your wireless device is connected
successfully, the LCD shows
Connected
.
If the connection failed, the LCD shows an
error code. Make a note of the error code, see
on page 25, and correct the
error.
Wireless setup is now complete. A four
level indicator at the top of your
machine’s LCD will show the wireless
signal strength of your access
point/router.
To install MFL-Pro Suite, continue to
step
11
.
For Windows
®
users:
Now go to
Page 28
For Macintosh users:
Now go to
Page 31
Note
If your wireless access point/router supports WPS
(PIN Method), you can also configure your
machine using the PIN (Personal Identification
Number) Method.
uu
Network User’s Guide:
Configuration using the PIN Method of WPS
(Wi-Fi Protected Setup)