Brother ADS-2600W, Quick Setup Manual

Page: 22 / 36

22
For Wireless Network Users
10
Manual setup from the
control panel using the
Setup Wizard (Macintosh,
mobile devices and
Windows
®
)
You cannot configure an enterprise wireless network
using the Setup Wizard from the control panel. If you
choose the SSID for configuring an enterprise
wireless network after searching the available SSIDs,
the message dialog about Enterprise Authentication
Method will appear.
To configure an enterprise wireless network, use
installer DVD-ROM and follow the instructions.
a
Press .
Swipe up or down, or press
a
or
b
to display
Network
, and then press
Network
.
Swipe up or down, or press
a
or
b
to display
WLAN
, and then press
WLAN
.
Swipe up or down, or press
a
or
b
to display
Setup Wizard
, and then press
Setup Wizard
.
When
Enable WLAN?
is displayed, press
Yes
to accept.
This will start the wireless setup wizard.
To cancel, press
No
.
b
The machine will search for available SSIDs. It
will take several seconds to display a list of
available SSIDs.
If a list of SSIDs is displayed, swipe up or down,
or press
a
or
b
to choose the SSID you wrote
down in step
9-b
on page 18. Select the SSID
you want to connect with, then press
OK
.
If the wireless access point/router of the
selected SSID supports WPS and the machine
asks to use WPS, go to
c
.
If the machine asks you to enter a Network
Key, go to
d
.
Otherwise, go to
e
.
c
Press
Yes
to connect your machine using
WPS. (If you choose
No (Manual)
to
continue manual configuration, go to
d
to enter
a Network Key.)
When the LCD shows
Start WPS
, press the
WPS button on your wireless access
point/router, and then press
Next
to proceed.
Go to
e
.
d
Enter the Network Key you wrote down in
step
9-b
on page 18 using the Touchscreen.
Press to cycle between lower case and
upper case. Press to cycle between
letters, numbers and special characters. (The
characters available may differ depending on
your country.) To move the cursor to the left or
right, press
d
or
c
.
(For more information, see Entering Text for
Wireless Settings on page 35.)
Press
OK
when you have entered all the
characters, then press
Yes
to apply your
settings.
e
Your machine will now try to connect to your
wireless network. It may take a few minutes.
f
A connection result message appears until the
OK
button is pressed on the LCD.
If your wireless device is connected
successfully, the LCD shows
Connected
.
If the connection failed, the LCD shows an
error code. Make a note of the error code, see
Troubleshooting on page 25, and correct the
error.
Wireless setup is now complete. A four
level indicator at the top of your
machine’s LCD will show the wireless
signal strength of your access
point/router.
To install MFL-Pro Suite, continue to
step
11
.
For Windows
®
users:
Now go to
Page 28
For Macintosh users:
Now go to
Page 31
Note
• If a list of SSIDs is not displayed, make sure
your access point is on. Move your machine
closer to the access point and try starting
from
a
again.
• If your access point is set to not broadcast the
SSID, you will have to manually add the SSID
name. For details, see the
Network User’s
Guide .