16
For Wireless Network Users
For wireless network interface users
8
Before you begin
First you must configure the wireless network settings of your machine to communicate with your network access
point/router. After the machine is configured to communicate with your access point/router, computers on your
network will have access to the machine. To use the machine from these computers, you will need to install the
drivers and software. The following steps will guide you through the configuration and installation process.
To achieve optimum results with normal everyday document scanning, place the Brother machine as close to the
network access point/router as possible with minimal obstructions. Large objects and walls between the two
devices as well as interference from other electronic devices can affect the data transfer speed of your documents.
Due to these factors, wireless may not be the best method of connection for all types of documents and
applications.
Although your Brother machine can be used in both a wired and wireless network, only one of the connection
methods can be used at a time.
The following instructions are for infrastructure mode (connected to a computer through an access point/router).
Infrastructure Mode
a
Access point/router
b
Wireless Network machine (your machine)
c
Wireless capable computer connected to the access point/router
d
Wired computer connected to the access point/router
e
Mobile Device connected to the wireless access point/router
Please make sure the wireless network settings of the machine match the access point/router.
Note
If you have previously configured the wireless settings of the machine you must reset the network settings
before you can configure the wireless settings again.
On your machine, press
and
Network
.
Swipe up or down, or press
a
or
b
to display
Network Reset
, and then press
Network Reset
.
Press
Yes
to accept. Hold down
Yes
for 2 seconds to confirm.
Note
To set up your machine in Ad-hoc mode (connected to a wireless capable computer without an access
point/router) you can find instructions in the
Network User’s Guide
on the DVD-ROM.
You can view the
Network User’s Guide
by following the instructions below.
1 Turn on your computer. Insert the DVD-ROM into your DVD-ROM drive.
For Windows
®
:
2 Choose your model and the language. The DVD-ROM top menu will appear.
3 Click
User’s Guides
, and then click
HTML documents
. The top page will appear.
4 Click
Network User’s Guide.
For Macintosh:
2 Double-click
User’s Guides
. Choose your model and the language.
3 Click
User’s Guides
.
1
2
3
4
5
