© 2018 BROSA AG, Tettnang, Germany
39 / 40
0656 FlexLim (Safe) system V1.00
...............................................................................................................................................................
...............................................................................................................................................................
............................................................................................................................................................
............................................................................................................................................................
Error code E 15X (where X is the configured CANopen input)
7.2 2D curve
Error code E C1X (where X is the channel of the 2D curve)
7.3 Multifunctional block (weighing)
Error code E 191 (where X is the channel of the multifunction block)
Error
Error of the CANopen stack
Possible
causes
1. The limit values are too narrow.
2. Damage to the sensor itself.
Possible
remedy
1. Correction of the "lower limit" for the sensor in the
corresponding input menu.
2. Sensor replacement.
Error
The input value is outside the 2D curve.
Possible
causes
1. The values of the 2D curve are too narrow.
2. Incorrect value of the input block obtained.
Possible
remedy
1. Correction of the "table values" for the input value.
2. Check the value of the input block.
Error
If the value from the SNR curve is undershot, this error is
set when the SNR test is activated.
Possible
causes
1. SNR value less than the default value of the curve.
Possible
remedy
2. SNR value less than the default value of the curve.
