To delete all IP addresses from an interface, enter the following command.
Brocade(config-if-1/1/1)# no ip address *
Syntax:
[no] ip address
{
ip-addr
|
*
}
Connecting network devices
Brocade devices support connections to other vendors’ routers, switches, and hubs, as well other
Brocade devices.
Connectors
For port pinouts, refer to
Brocade ICX 7250 Switch Technical Specifications
on page 73.
Cable specifications
For information about supported transceivers and cable lengths and types, refer to the Brocade optics
family datasheet.
Connecting to Ethernet or Fast Ethernet hubs
For copper connections to Ethernet hubs, a 10/100Base-TX or 1000Base-T switch, or another
Brocade device, a crossover cable is required (see the figures below). If the hub is equipped with an
uplink port, it requires a straight-through cable instead of a crossover cable.
NOTE
The 802.3ab standard (automatic MDI or MDIX detection) calls for automatic negotiation of the
connection between two 1000Base-T ports. In this case, a straight-through cable may work just as well
as a crossover cable. For more information about this feature, refer to the
FastIron Ethernet Switch
Security Configuration Guide
.
Connecting network devices
60
Brocade ICX 7250 Switch Hardware Installation Guide
53-1003622-02