DANGER
Mount the devices you install in a rack as low as possible. Place the heaviest device at the
bottom and progressively place lighter devices above.
Desktop installation
Complete the following steps to install the ICX 7250 device on a desktop or other flat surface.
NOTE
The device shown in the diagram may be different from the one you have.
FIGURE 11
Attaching the adhesive feet
1. Attach the four adhesive feet to the bottom of the device. If installing multiple devices, attach the
adhesive feet to each device.
2. Set the device on a flat desktop, table, or shelf near an AC power source. Make sure that adequate
ventilation is provided for the system. A 7.62 cm (3 in) clearance is recommended on each side.
3. If installing a single device only, go to the “Powering on the system” task. If installing multiple devices
place each device squarely on top of the one below.
Rack mount installation (2-post)
The devices use stationary mounting when mounted in a rack.
DANGER
Make sure the rack housing the device is adequately secured to prevent it from becoming
unstable or falling over.
Desktop installation
Brocade ICX 7250 Switch Hardware Installation Guide
27
53-1003622-02