Broadcast Tools WVRC-8, Installation And Operation Manual

Page: 9 / 42

e-mail:
support@broadcasttools.com
voice:
360.854.9559
fax:
866.783.1742
9
WVRC-8 Installation and Operation Manual
INSTALLATION
Name Type Description
ST1A - 8A Connector Status opto-isolators. When configured for DRY (fac-
tory default) this terminal is ground. When configured
for WET (floating), this terminal is the anode via a
2.2K ohm current limiting resistor. (BOTTOM)
ST1B - 8B Connector Status opto-isolators. This terminal is always the cath-
ode (BOTTOM)
K1NC - K4NC Connector Normally closed, dry relay contacts. Raise function
(TOP)
K1CM - K4CM Connector Common (wiper), dry relay contact. Raise function
(TOP)
K1NO - K4NO Connector Normally open, dry relay contact. Raise function
(TOP)
K5R - K8R Connector Normally open, dry relay contact. Raise function
(TOP)
K5R - K8R Connector Common (wiper), dry relay contact. Raise function
(TOP)
K1NC - K4NC Connector Normally closed, dry relay contact. Lower function
(BOT)
K1CM - K4CM Connector Common (wiper), dry relay contact. Lower function
(BOT)
K1NO - K4NO Connector Normally open, dry relay contact. Lower function
(BOT)
K5L - K8L Connector Normally open, dry relay contact. Lower function
(BOT)
K5L - K8L Connector Common (wiper), dry relay contact. Lower function
(BOT)
CONFIGURE Dipswitch Used to configure the unit. Refer to table of contents.
TEMP 3.5mm Jack Temperature probe input jack. T/R/S.
PF 2.1mm Jack Power Failure power jack (optically-isolated). 6 - 12
VDC,center positive.
BT-LINK Dual RJ45’s RJ45, used for future system expansion.
12VAC 2.1mm Jack System power supply input. 12 volts AC.
GND # 6 screw System ground screw. Tie to station ground system.