e-mail:
voice:
360.854.9559
fax:
866.783.1742
25
WVRC-8 Installation and Operation Manual
SETUP
Web and/or Dial-up Notice
The WVRC-8 can be used for dial-up only, web only or a combination of both. It is sug-
gested that the user configure for both the dial-up and WEB operation. Some features
such as the scheduler and logger will require the user to configure the web portion of the
WVRC-8 even if web access isn’t being used.
WEB Setup
The WVRC-8 firmware supports an HTTP (web) interface on TCP port 80, which is user
programmable. The default page contains a Java applet used to monitor and control the
WVRC-8.
CAUTION! NEVER DOWNLOAD FIRMWARE UPDATES OR CHANGES TO
THE XPORT WEBSERVER UNLESS REQUESTED BY BROADCAST TOOLS.
DOING SO DELETES ALL SOFTWARE AND VOIDS ALL WARRANTIES FROM
BROADCAST TOOLS, INC.
Ethernet setup
NOTE:
If you are not familiar with Ethernet enabled equipment, it may be useful to
contact your IT department, network administrator or network consultant.
CAUTION! Assigning an IP address already in use by another device may cause prob-
lems with your network!
Information you’ll need to configure the WVRC-8
Factory default settings:
IP Address:
192.168.1.55
Subnet Mask:
255.255.255.0
Default Username wvrc8 or admin (lower case)
Default Password wvrc8 (lower case) or 1234
1 - An available Static IP address to assign to the WVRC-8.
NOTE:
If a static IP isn’t available, consider using
http://www.dynip.com/
2 - The network’s subnet mask.
3 - Your network’s gateway address (essential for proper operation).
4 - The IP address of the email server.
5 - The SMTP port used by your email server (usually 25).
6 - Up to four email addresses to which you want to send email alarms.
WEBSITE:
Visit our web site for
product updates and
additional information.
