Broadcast Tools WVRC-8, Installation And Operation Manual

Page: 26 / 42

e-mail:
support@broadcasttools.com
voice:
360.854.9559
fax:
866.783.1742
26
WVRC-8 Installation and Operation Manual
SETUP
NOTE:
The network administrator may be required to enter the IP address of the
WVRC-8 into the SMTP server to allow email forwarding. In some installations, an email
forwarding service such as
http://www.smtp.com/
may be required for the email function to
operate properly.
7 - IP address of a NTP timeserver, if used.
NOTE:
Here is the IP address for the NIST NTP server 132.163.4.103
(
http://tf.nist.gov/service/time-servers.html
) or pool.ntp.org.
The WVRC-8’s RJ-45 ( Network ) is normally attached to a DSL/Cable router, Ethernet
hub or switch. The supplied “Device Installer” software should be used to configure the
IP address of your WVRC-8.
The “Device Installer” version 4.2 software or greater is also available on our web site:
www.broadcasttools.com
, under downloads or on the supplied CD.
NOTE:
The Device Installer application
requires Microsoft’s .NET Framework version 1.1
.
If you do not already have .NET Framework version 1.1 or greater (dotnetfx.exe)
installed, you can download it from the Microsoft web site.
1 - Install the “Device Installer” software on the PC used for the WVRC-8 setup.
NOTE:
The WVRC-8 applet requires a compatible Java Runtime Environment Version
6 Update 6.6 or greater). If your browser is lacking Version 6 Update 6.6 or greater, we
have provided a link to download the required application:
http://www.java.com/en/download/index.jsp
, then click on the “Free Java Download” button
and follow the prompts. This is also available on our web site:
www.broadcasttools.com
,
under downloads or on the supplied CD.
2 - Connect the supplied BLUE straight-through CAT 5 cable to the RJ-45 connector on
the WVRC-8 labeled ( Network) and the other end to your hub or switch.
NOTE:
If you are attaching the WVRC-8 directly to your computer, you MUST use the
supplied GRAY Xover CAT 5 cable and set your PC’s IP for 192.168.1.60
3 - Connect the supplied 12 VAC @ 1amp power supply to the WVRC-8’s power jack
labeled
12VAC/1 Amp . Verify that the front panel power LED and left “LINK” LED
above the “NETWORK” RJ-45 are illuminated
Ethernet port LED indicator functions