e-mail:
voice:
360.854.9559
fax:
866.783.1742
4
WVRC-8 Installation and Operation Manual
INTRODUCTION
INTRODUCTION
Thank you for your purchase of a
Broadcast Tools® WVRC-8, Eight Channel WEB and Voice Dial-up
Remote Control System
(referred to as the WVRC-8 throughout this manual). We’re confident that this product
will give you many years of dependable service. This manual is intended to give you all the information needed to
install and operate the Broadcast Tools® WVRC-8.
SAFETY INFORMATION
Only qualified personnel should install Broadcast Tools® products. Incorrect or inappropriate use and/or
installation could result in a hazardous condition.
Broadcast Tools, Inc., is unable to support NON-Broadcast Tools software, hardware or NON-Broadcast Tools comput-
er/hardware/software problems. If you experience these problems, please research your hardware/software instruction
manuals or contact the manufacturers technical support department.
Only qualified technical personnel should install the WVRC-8. Any attempt to install this device by a person who
is not technically qualified could result in a hazardous condition to the installer or other personnel, and/or damage to
the WVRC-8 or other equipment. Broadcast transmitters can operate at voltages that are potentially lethal. Please
ensure that proper safety precautions have been made before installing this device. If you are unfamiliar with this type
of equipment, please contact a properly qualified engineer to handle the installation and setup of the WVRC-8.
Broadcast Tools® Products, as with any electronic device, can fail without warning. Do not use this product in
applications where a life threatening condition could result due to failure. Serious injury or death can occur if a
command channel is activated while you are performing maintenance on your equipment. If you are performing
maintenance on your equipment, you should press the “PGM” button on the front panel of your WVRC-8 forcing
the unit in to local mode. The “PGM” LED will illuminate. Local mode prevents the unit from performing relay
commands.
For additional safety, it is strongly recommended that, in addition to setting the WVRC-8 in to OP/PGM mode,
the remote/local switch on any transmitter or high voltage equipment also be set to local mode.
While the WVRC-8’s relays are physically capable of handling 250 VAC, this practice is extremely dangerous and
should never be attempted. The pluggable euroblock screw terminals are not designed to shield humans from poten-
tially dangerous voltages. Contact with high voltages can cause serious injury or death. The maximum recommended
voltage for the WVRC-8 is 30V. Switching of high voltages should only be done external from the WVRC-8 and in a man-
ner that isolates the voltages from accidental contact with humans.
WHO TO CONTACT FOR HELP
If you have any questions regarding your product or you need assistance, please contact your distrib-
utor from whom you purchased this equipment.
If you would like more information about Broadcast Tools® products, you may reach us at:
Broadcast Tools, Inc.
131 State Street
Sedro-Woolley, WA 98284-1540 USA
Voice: 360.854.9559
Fax:
866.783.1742
Internet Home Page:
www.broadcasttools.com
E-mail:
THANK YOU FOR CHOOSING
BROADCAST TOOLS® BRAND PRODUCTS!
CAUTION!
Broadcast Tools®
Products, as with any
electronic device, can
fail without warning.
Do not use this product
in applications where a
life threatening condition
could result due to failure.
NOTE:
This manual should be
read thoroughly before
installation and operation.
WEBSITE:
Visit our web site for
product updates and
additional information.
