e-mail:
voice:
360.854.9559
fax:
866.783.1742
20
WVRC-8 Installation and Operation Manual
PROGRAMMING
Recording Voice Messages
The following steps are required to record voice messages into the WVRC-8.
NOTE:
If the time allotted for the message you are recording elapses before the
“PGM” button is pressed, it will turn off automatically.
Example
: To record the greeting message, press the “PGM” button, enter 00 on the key-
pad, speak the new greeting message, then press the “PGM” button again.
1 - Connect a TT telephone to either the front or rear panel RJ-11 jacks labeled “PGM”.
2 - Press the front panel “PGM” button; this should illuminate the front panel “PGM” led.
3 - Enter the two-digit address of the message you wish to program. The list of messages
are below.
4 - The red “REC” led will illuminate. As soon as it lights, begin speaking the new mes-
sage into the telephones mouth piece.
5 - When finished, press the PGM button again, the “REC” and the “PGM” led’s will
extinguish.
NOTE:
The following above procedures allows changing any of the messages.
If you want to listen to a message, without recording, preface the address with
the asterisk
(*)
key.
Example:
To hear the current greeting message, press the “PGM” button and
Enter
*00
. The current greeting message will play. Here is a list of the voice
messages pre-recorded in the WVRC-8.
