Brillion Landcommander II LCS11152, Operator'S Manual

Page: 7 / 62

998rev401 5K821
1. DO NOT LUBRICATE, ADJUST OR REPAIR WHEN MACHINE IS IN MOTION.
2. DO NOT TOW OR TRANSPORT FASTER THAN 15 MILES PER HOUR.
3. DO NOT RIDE OR ALLOW OTHERS TO RIDE ON THE MACHINE.
4. BLOCK UP ALL HYDRAULICALLY OR MECHANICALLY RAISED COMPONENTS TO PREVENT
UNINTENDED LOWERING OR LOWER THE MACHINE TO THE GROUND TO MAKE ADJUSTMENT
OR REPAIRS WHEN NOT IN USE.
5. KEEP ALL PERSONS AWAY FROM MACHINE DURING HITCHING AND OPERATING.
6. SLOW DOWN BEFORE MAKING SHARP TURNS OR USING THE BRAKES.
DRIVE SLOWLY OVER ROUGH GROUND, SIDE HILLS, AND AROUND CURVES TO AVOID
TIPPING.
7. COMPLY WITH ALL LAWS WHEN TRANSPORTING THE MACHINE ON PUBLIC ROADWAYS.
8. INSTRUCT ALL OPERATORS IN THE SAFE OPERATION OF THE MACHINE.
REVIEW THE OPERATOR’S MANUAL FOR CORRECT PROCEDURES.
9. BLOCK IMPLEMENT TO PREVENT MOVEMENT WHEN UNHITCHED FROM TRACTOR.
8J310
CAUTION
WARNING
DO NOT GO NEAR LEAKS
HIGH PRESSURE OIL EASILY PUNCTURES
SKIN CAUSING SERIOUS INJURY,
GANGRENE OR DEATH.
IF INJURED, SEEK EMERGENCY MEDICAL
HELP. IMMEDIATE SURGERY IS
REQUIRED TO REMOVE OIL.
DO NOT USE FINGERS OR SKIN TO
CHECK FOR LEAKS.
LOWER LOAD OR RELIEVE HYDRAULIC
PRESSURE BEFORE LOOSENING FITTINGS.
10813A
SPRING UNDER LOAD
DO NOT DISASSEMBLE WITHOUT USE OF
SERVICE TOOL AND FOLLOWING PROCE-
DURE
OUTLINED IN OPERATOR’S MANUAL.
SPRING IS LOADED AND IMPROPER
REMOVAL OF BOLTS COULD RESULT
IN SERIOUS INJURY.
2K762
WARNING
1. 8J310 - Caution List Decal
2. 3K706 - Hydraulic Leak Caution
3. 2K762 - Spring Under Load Warning
4. 2J431 - Reflective Amber Decal
5. 2J430 - Reflective Red Decal
6.. 2K955 - Service of Preloaded Shank
Decal
SERVICE OF PRELOADED SHANK ASSEMBLY
2K955
4
5
1
2
3
6
1. Install the service tool as shown.
2. Slightly loosen bottom bolts
of rear bracket.
3. Retract ratchet to rmove bolt as
shown.
4. Extend ratchet to pivot rear bracket
and relieve spring force.
5. Service parts and reverse steps to
load assembly.
REFER TO OPERATOR’S MANUAL FOR
COMPLETE SERVICE & SAFETY
INSTRUCTIONS.
Figure 2A
SAFETY WARNING SIGNS
The “WARNING” signs illustrated on this page are placed on the machine to warn of hazards.
“The warnings found on the sign are for your personal safety and those around you.” Their locations
on the machine are shown on the following page. OBSERVE THESE WARNINGS!
Keep these signs clean so they can be observed readily. Wash with soap and water or cleaning
solution as required.
Replace “WARNING” signs should they become damaged, painted over or if they are missing.
When replacing decals, clean the machine surface thoroughly using soap and water or cleaning
solution to remove all dirt and grease.
Page 5