Brillion Landcommander II LCS11152, Operator'S Manual

Page: 54 / 62

998rev401 5K821
#2K501 CAPSCREW
1/4” x 2 1/2”
TO R.H. LAMP
ASSEMBLY
REAR
#4K826 TANDEM
HAUL ADAPTER
WISHBONE
WIRING HARNESS
TO L.H. LAMP
ASSEMBLY
STRAIGHT SECTION
WIRING HARNESS
TO
TRACTOR
#6J150
1/4” LOCKNUT
REAR HITCH
#1C229 CAPSCREW
1/4” x 3/4”
Attach center connector of “wishbone” wiring harness to tandem haul adapter. Then run
wishbone harness ends over to L.H. and R.H. lamp assemblies.
( Important : Wires are color
coded on wishbone harness. Run end with yellow wire along frame members to left
side lamp assembly, and assemble connectors. Run end with green wire along frame
members to right side lamp assembly, and assemble connectors.
) Attach “straight
section” wiring harness connector to tandem haul adapter. Then run this harness along
machine frame members over to front of drawbar.
If your machine is not equipped with a rear hitch, you have no need to use the tandem haul
adapter. In this case, simply plug the “straight section” connector into the center connector of
the wishbone harness. Then run wires to lamp assemblies along frame members as described
above.
All wires must be firmly attached to machine frame members so they don’t droop or become
torn loose by field debris. Use plastic cable ties, provided, and electrical tape to secure all
wiring.
Figure 32
Page 46