Use and Maintenance Manual – VER. 2016-02
Page 4
ALWAYS UNPLUG THE POWER SUPPLY CABLE FROM THE SOCKET BEFORE MOVING THE MACHINE.
The environmental working conditions must comply with the following requirements:
-
Temperature from 0° C to + 45° C
-
Relative humidity from 20% to 95%
5. UNPACKING
After removing the packaging, check the integrity of the appliance making sure there are no visibly damaged parts.
In case of doubt, DO NOT USE THE MACHINE and consult professionally qualified personnel (dealer or manufacturer). The
packaging materials (plastic bags, expanded polystyrene, nails, screws, pieces of wood, etc.) must not be left within reach of
children as they are potentially dangerous. Take the packaging materials to appropriate collection points if polluting or non-
biodegradable.
MAKE SURE YOU HAVE NOT THROWN AWAY THE ACCESSORY BOX WITH THE PACKAGING.
6. INSTALLATION AND COMMISSIONING
After unpacking the various parts of the wheel balancer, ensure they are intact and check for any anomalies, then assemble the
parts.
6.1 Electrical connection
The standard version of the machine must be connected to a mains 230V SINGLE PHASE.
To complete the electric connection, apply the plug provided for in the user's country to the machine power supply cable.
ALL THE OPERATIONS REQUIRED TO MAKE THE ELECTRICAL CONNECTION AND ANY WORK (HOWEVER
SLIGHT) ON THE ELECTRICAL PARTS MUST BE CARRIED OUT BY QUALIFIED PERSONNEL.
Electrical cables must be sized according to the electrical power absorbed by the machine. The user must:
- check that the supply voltage corresponds to the voltage indicated on the nameplate of the machine;
- check the condition of wires and the presence of the ground conductor;
- check that the machine is connected to its own electrical connection, fitted with a proper automatically shutting off device against
overcurrent, with 30 mA trip sensitivity (circuit breaker);
- connect the power supply cable to the plug with the utmost care, in accordance with applicable regulations.
WHEN THE MACHINE IS OFF AND UNUSED FOR LONG PERIODS, IT IS NECESSARY TO DISCONNECT THE
POWER SUPPLY PLUG TO PREVENT USE BY UNAUTHORISED PERSONNEL.
IF THE CONNECTION TO THE ELECTRICAL LINE OCCURS DIRECTLY THROUGH THE GENERAL ELECTRICAL
PANEL, WITHOUT THE USE OF ANY PLUG, IT IS NECESSARY TO SET UP A KEY SWITCH TO RESTRICT THE
MACHINE USE EXCLUSIVELY TO QUALIFIED PERSONNEL.
IN CASE OF OPERATIONS ON LINES, MOTOR INTERNAL PARTS OR ANY ELECTRIC EQUIPMENT, IT IS
NECESSARY TO CUT OFF POWER FIRST.
DO NOT REMOVE, DAMAGE AND MAKE HAZARD, WARNING, INSTRUCTION AND CAUTION STICKERS
ILLEGIBLE. REMOVED OR DAMAGED STICKERS CAN BE FOUND AT THE NEAREST DEALER OF THE
MANUFACTURER.
Summary of Contents for VULTURE BP46
Page 1: ...BP46 VULTURE ...
