Use and Maintenance Manual – VER. 2016-02
Page 36
To exit the testing program, press [F+P9]
.
SMo Shaft smoothness test
This program allows you to measure the smoothness of the shaft.
These values are used by technical support personnel to determine the functioning status of the machine.
To measure the smoothness of the shaft proceed as follows:
1.
Remove the wheel and any other accessory from the shaft. This is very important because otherwise the value measured
will be completely meaningless;
2.
Press [P8] Start
or lower the guard: the machine runs a sequence of brief motor ignitions, and each time it
lets the shaft stop spinning by inertia;
3.
Upon completion of the sequence the machine displays the value of the smoothness measured. The smoothness value is
not absolute but refers to a sample machine whose smoothness value has been set at 1.00. The value measured is stored
in the permanent memory of the machine in order to be used in the functions that are connected to the smoothness of
the shaft.
To exit the testing program, press [F+P9]
.
Ret Returns to SERVICE mode
This Testing Program menu option returns the machine to SERVICE mode.
21. SIGNALLING
When abnormal operating conditions occur, the machine emits two types of signal:
Error
Warning
The Error signal is always accompanied by a triple beep indicating that the machine cannot run the command given by the operator,
or, during operation, conditions were encountered that prevent the action in progress from continuing.
The Warning signal is always accompanied by a double beep that prompts the operator to perform a particular action, or refers to
the fact that the machine has changed status. In any case, the requested operation is not prevented, or the current function is
completed.
21.1 Error codes
The machine indicates error conditions by alternating the display of an error code with a brief description (in English) of the error
cause. The list of error codes and brief descriptions is provided in table T21.1. The machine displays the code for different times
depending on the error code itself, as indicated in the column "Error display" in table T21.1.
Table T21.1: Error codes
Error
code
Brief description
Display error
(1)
Description
Notes
000 to
009
INT ERR
Machine parameters internal
error.
Contact technical support.
010
REV SPN
Reverse rotation of the wheel.
Contact technical support.
Summary of Contents for VULTURE BP46
Page 1: ...BP46 VULTURE ...