Use and Maintenance Manual – VER. 2016-02
Page 27
8.
Manually turn the wheel clockwise passing the imbalance point (previously identified) up to the point at which you want
to apply the external weight W2 and press [P1]
to confirm. The angle formed by weights W1 and W2 must
not be less than 120° and must include external weight W.
9.
If external weight W is not included between the positions of weights W1 and W2, the machine will display error code Err
052, thus indicating to repeat the procedure in step 7. If instead the angle chosen is less than 120°, the machine will
immediately display the external weight W2 value.
10.
Block the wheel and apply external balancing weight W2 as indicated on the display. Refer to table T16.2 for the exact
application point of the external weight.
11.
Manually rotate the wheel until external weight value W1 appears on the left display.
12.
Block the wheel and apply external balancing weight W1 as indicated on the display. Refer to table T16.2 for the exact
application point of the external weight.
13.
The procedure of the Hidden Weights program has been completed: press [F+P5]
to exit
and perform the balancing test spin.
NOTE: Picture F18.1 indicates the position of the external weight at the 12 o’clock, but this is valid only for certain Progr
am Types.
Hidden Weights Program with enabled sensor
To use this program, proceed as follows:
1.
Perform wheel balancing without applying the external weight.
2.
Rotate the wheel manually until all external imbalance search LEDs light up (see detail [9] in Picture F17.1).
3.
For easy of use make a reference mark on the tyre in the imbalance position at 12 o’clock;
4.
Press [F+P5]
to run the Hidden Weights program. If the wheel is balanced on the external
side, the machine will display error code Err 050 to indicate that the operation is not allowed.
5.
If there is an imbalance on the external side instead, the machine will display the message shown in picture F17.2;
6.
Manually turn the wheel anti-clockwise and make a mark on the first spoke at the 12 o'clock position;
7.
Confirm by pressing
;
8.
The machine displays the message in picture F17.3;
9.
Manually turn the wheel anti-clockwise and make a mark on the second spoke at the 12 o'clock position;
10.
Confirm by pressing
;
11.
The display shows the two weights to be applied behind the two spokes;
12.
Behind the two spokes, apply weights W1 and W2 at 12 o'clock, shown on the screen;
13.
The procedure of the Hidden Weights program has been completed: press [F+P5]
to exit
and perform the balancing test spin.
Summary of Contents for VULTURE BP46
Page 1: ...BP46 VULTURE ...