36
8.2.3
GPS
GPS Status
shows whether the MDR sees the presence of the GPS module.
This will say detected or not detected.
GPS Satellite Count
shows how many satellites the GPS module sees, the
value can be between 1 and 24.
Speed
indicates the current speed of the vehicle.
GPS Figure 122
8.3
Server Status
Centre Server #
displays the current server configuration details. A maximum of
6 centre servers can be stored.
Server Status
shows connection state of the chosen server. This can either be
connected or unconnected.
Network Type
indicates the type of connection interface the centre server will
use to attempt to communicate with the MDR Server. There are three options:
Ethernet, Wi-Fi and mobile network.
Server protocol type
shows the built-in proprietary communication protocol
that will be used between the MDR unit and MDR Server. This can either be MDR5
or maintenance. Ensure that this is set to MDR5.
Server IP Address
displays the IP address of the MDR Server. This can either
be internal or external IP address.
Port
shows the port used for communication between the MDR and MDR server.
Server Status Figure 123
8.4
Environment
Voltage (V)
indicates the current voltage level the MDR is receiving.
Device Temperature (°C)
shows the physical temperature of the MDR unit.
HDD Heater Status
indicates the current state of the heater. The heater is
found on the HDD inside the MCU. The heater turns on automatically once the
environment temperature reaches 0°C.
Ignition Status
indicates the current state of the ignition wire
– yellow on
MDR power cable.
Environment Figure 124
8.5
Storage
Storage Type
refers to the medium of storage. By default, HDD and SD (Internal)
should be displayed. FRONT USB may also be displayed here if a flash drive is
connected to the front USB port, found on the docking station.
Warning: Do not connect an external HDD to the front USB port. Only USB
Flash drives (which contain flash memory) is supported by this port.
Brigade will not be held responsible for incorrect use of this port.
Status
is an indication of the state of the storage medium. There are three states
that can be shown: RECORDING, NORMAL or FAILED. Recording refers to when
the medium is currently being recorded on. Normal is when the medium is not
currently being recorded on but it has no errors/failures. If a state of failed is
displayed, the MDR should be restarted and the storage medium formatted or
replaced.
Free/Total
shows the capacity the storage media. In all storage media, once
formatted, some space will be lost due to binary math. In general, for each gigabyte,
you’ll have about 70MB less space.
Remain Time
shows the remaining time on each storage media that is currently
being recorded on.
Storage Figure 125
Summary of Contents for MDR-504-500
