26
Laddermill Owner’s Manual—2017
Channel Assembly
Once the unit is located roughly at the installa on
loca on you will need 4 people to li the Channels
up. They will stand and be fairly stable once raised.
The Laddermill should be placed face down and a
minimum of 48” from any rear walls or obstruc ons.
There is a slight curve to help make li ing easy on
the lower wood plates. Be mindful of the hydraulic
unit, do not step on it or roll the Laddermill over the
top of it.
Be careful if you are on a slippery floor, it may help
to place a small piece of rubber underneath the
lower wood li ing plates, or have one of your
helpers secure the lower end of the wall while three
people begin the li .
A er the unit is raised, one person should be
responsible for holding onto it and maintaining its
stability un l the A-frame is fully installed.
Wood plates should be 48” from the rear wall
48”
Place hydraulic unit safely to the side
Summary of Contents for Laddermill Ascender
Page 2: ......
Page 4: ...ii Laddermill Owner s Manual 2017 ...
