30
Laddermill Owner’s Manual—2017
Assembly
NOTE:
As the Laddermill is transported, air may become trapped in the hydraulic system and
cause the pump to cavitate: this causes a loud rumbling and chain noise. It sounds bad, but it is
natural and will go away with ini al use. To help purge the air, stand on the ground and slowly
turn the ladder with your hands, le ng it rest every minutes. You can also just climb. The unit will
get smoother and smoother with use. There is varia on: some units may take longer than others.
Before finishing the install inspect the Laddermill:
1) Make sure the mer-counter is working properly. If it does not count feet as the wall is
moving, check that the magnets and sensor are properly installed and adjusted
2) Check the auto-stop func on. Start climbing at a moderate speed. If you stop moving up, the
wall should con nue down and stop moving downward when your foot reaches the bo om of the
wall and triggers the foot peddle at the bo om of the channel. Do this test at all the angles.
3) Check the x-bracing on the A-frame. They should be equally adjusted (the turnbuckles should
look the same) and ght. The Laddermill core should be ver cal.
If you have any issues or ques ons give us a call (800-707-9616) .
Final Note - Tests
Summary of Contents for Laddermill Ascender
Page 2: ......
Page 4: ...ii Laddermill Owner s Manual 2017 ...
