29
Laddermill Owner’s Manual—2017
Shrouds and Counter
Remove the top wood plate and bolt the top shroud in place. The bolts will be in bag
LM-3, you will need4 bolts, lockwashers, and regular washers.
Then bolt the lower shrouds on with the remaining hardware in LM-3
Top Shroud
Bo om Shroud
The Counter screws directly onto the top of the right A-
frame. It may be easier to remove the ball mount from
the counter and a ach the plate separately. A er the
counter is screwed into place plug the sensor wire from
the channel assembly into the counter, this wire is
located just behind the A-frame bearing.
Last, the power wire for the counter is located at the rear
of the A-frame. Plug the male end directly into the
counter and then, at the bo om of the A-frame a ach
the power supply and plug into your power outlet. The
counter should turn on. There is a long length of wire
included to give you flexibility in your loca on. Any excess
wire can be coiled up and placed into the A-frame.
Summary of Contents for Laddermill Ascender
Page 2: ......
Page 4: ...ii Laddermill Owner s Manual 2017 ...
