Brewer Fitness Laddermill Ascender, Owner'S Manual

Page: 21 / 38

17
Laddermill Owner’s Manual—2017
Troubleshoo ng
Problem Cause Solu on
En re Laddermill wobbles or moves Exterior X-bracing too loose
Tighten the exterior X-bracing
making sure that the en re frame
is square and level (
Pg. 23)
Speed control lever does not work
control cables may need ad-
jus ng
Remove hydraulic cover and in-
spect the path and ghtness of the
control cable. (
Pg. 24)
Auto stop doesn’t work or works erra -
cally
Control cable needs adjustment
Check and adjust the Control cable
on the right side of the machine.
(
Pg. 24)
Wall is sluggish: lighter weights will not
pull wall down
Either the speed control cable
needs adjustment or the ends
of the rungs are rubbing the
channels
Tighten the cable adjuster ( Pg. 24)
and check the x-bracing ( Pg. 23)
Display does not power on
The Laddermill is not plugged
in, not receiving adequate pow-
er, there is a loose connector,
or a wire is cut
Check that the Laddermill is
plugged in and the power outlet is
working. Check all connectors and
cables for good fit and good condi-
on
Display is powered up but will not
start coun ng
Sensor and magnets not adjust-
ed properly, broken, or missing Check the sensor located on the
inside top of the right channel.
The gap should be no
more than 1/8” (
Pg. 25)
Angle Changer does not lock in place Cable is loose or trapped Tighten the cable adjuster ( Pg. 23)