9
EN
Note:
Plastic pole placed under
the egg tray, please check
before disposal of the
packaging.
PLASTIC MOUNTING INSTALLATION
1.
Fasten the plastic pole onto your fix pole with mounting base, clamp, washers, screws and
nuts. Following below 1a, 1b, 1c sequences:
1a. Insert the plastic pole into the hole of the mounting
stand, and then secure it with the screw and nut.
1c. Fasten the mounting stand and
clamp together onto a fix pole with
4 long screws and nuts.
1b. Apply 2 rubber pads on the mounting clamp.
2. Apply 4 rubber pads on the inner sides of the mounting base
and clamp of the 7-in-1 sensor, and loosely fasten them
together.
3. Place the 7-in-1 sensor over the mounting pole and align it to
North direction before fastening the screws.
MOUNTING POLE AND DIRECTION ALIGNMENT
Install the wireless 7-IN-1 sensor in an open
location with no obstructions above and
around the sensor for accurate rain and wind
measurement. Install the sensor with the
smaller end facing the North to properly orient
the wind direction vane. Secure the mounting
stand and bracket (included) to a post or pole,
and allow minimum 1.5m off the ground.
Point to
NORTH
1.5 meter
off the
ground
Fixed pole
package not
included
INSTALL WIRELESS INDOOR SENSOR
1. Remove the battery door of the sensor.
2. Use the channel slide switch to set the channel number for the
sensor (e.g. Channel 1)
3. Insert 2 x AA size batteries into the battery compartment and close
the battery door according to the polarity information marked on the
battery compartment.
4. The sensor is in synchronization mode, and can be registered to the
console within the next few minutes. The transmission status LED
will begin to flash every 1 minute.
NOTE:
-If you need to re-assign the sensor channel, slide the channel slide switch to the new channel
position. For the new channel number to be effective, press
[ RESET ]
key on the sensor.
- Avoid placing the sensors in direct sunlight, rain or snow.
-To avoid the sensor/s and console pairing failure during new console setup, please power up
the sensor/s first, and then press
[ RESET ]
key on the main unit (no need on sensors).
