7
EN
SMART VENTILATING FAN
Ventilating fan
A ventilating fan is installed inside the radiation shields to reduce the impact of sun heat effect.
The fan is driven by solar panel and will automatically start spinning under 2 conditions:
1. When the sun is shining on the solar panel, and 2. Average windspeed is below 5m/s for 1
minute.
INSTALLATION AND SETUP
Your console can pair up with one wireless 7-in-1 outdoor sensor and up to 7 other wireless
sensors like Thermo/Hygro (ST2001H), Pool/Spa (SP60010) or Soil sensor (SM60020) (sold
separately).
INSTALL WIRELESS 7-IN-1 SENSOR
Your wireless 7-IN-1 sensor measures wind-speed, wind-direction, rainfall, UV, light intensity,
temperature and humidity for you. It’s assembled and calibrated for your easy installation.
INSTALL BATTERIES
Unscrew the battery door at bottom of unit and insert the
batteries according to the +/- polarity indicated. Screw the
battery door compartment on tightly.
NOTE:
-
The red LED will begin flashing every 12 seconds.
Screw
location
3 x AA
batteries
MOUNTING KIT INSTALLATION
1. Pole mounting stand x 1
2. Mounting clamp x 1
3. Plastic pole x 1
4. screws x 4
5. Hex nuts x 4
6. Flat washers x 4
7. screw x 1
8. Hex nut x 1
