19
Doc. HD40-0007-02 En-Eu L-4
Charging the Battery (PowerShell Only)
WARNING:
Only charge the
Battery
with
the supplied
Z1
PowerShell
and the supplied
Z1
Power Supply.
Do not use any other battery
charger, AC adapter, or other device to charge
the
Battery
.
With both the
Z1
and the
Battery
fully inserted into the
PowerShell
, plug the
Power Supply
into the
PowerShell
as
shown and into a power outlet. (Figure 13)
CAUTION:
Make sure your
Battery
is fully
charged before commencing CPAP therapy
using the
PowerShell
. The battery life of a fully
charged battery in the
PowerShell
is typically
8 hours or longer, after which treatment will
terminate. To recharge the
Battery
, see “Charging
the Battery”
Ensure the
Z1
is in standby mode (display reads 0.0). The
Battery
will not charge unless the
Z1
is in standby mode. The
Battery
status indicator on the
Z1
will flash when the
Battery
is charging.
The number of solid bars indicates the current level of charge.
(Figure 14)
The battery status indicator will stop flashing when the battery
is fully charged. Typically it will take 8 hours to fully charge the
battery. After a few minutes, the back lit display will turn turn off.
This is to conserve power. It does
not
indicate that the battery is
fully charged.
NOTE:
The battery will not charge if you are using the device at the
same time.
Care
The
Z1
System
needs periodic care. It is the user’s responsibility to be aware of the following items
for care:
• Inspections
• Cleaning
•
Filter
Replacement
•
CPAP Tube
Replacement
• Reminders and Fault Conditions
Inspections
Before each use carefully inspect the
Z1
,
CPAP Tube
,
Filter
, and mask for signs of wear, damage or
discoloration. For replacement parts visit www.breas.com.
Figure 13
Figure 14
