13
Doc. HD40-0007-02 En-Eu L-4
Power Supply
WARNING:
The
Z1
must only be used
with the
Z1
Power Supply
(or the optional
Z1
PowerShell
with Breas
Battery
). DO NOT use any
other power source with the
Z1
.
CAUTION:
Make sure the AC power cord
IS NOT plugged into an AC power outlet before
continuing to the next step.
1. Plug the AC power cord into the AC Adapter.
2. Plug the AC power cord into a wall outlet.
3. Plug the AC Adapter into the
Z1
. (Figure 4)
4. The
Z1
will power up and cycle through a series of
startup displays.
5. After about 10 seconds, the
Z1
will enter standby
mode. The display will read 0.0. (Figure 5)
NOTE:
The
Z1
display will be active whenever
the device is receiving power.
PowerShell and Battery
(Available Separately or as Part of Z1 Unplugged)
WARNING:
The
Z1
must only be used with
the optional
Z1
PowerShell
with Breas
Battery
(or the
Z1
Power Supply
). DO NOT use any other
power source with the
Z1
.
1. Slide the
Battery
with the attached
Shuttle
into the
lower bay of the
PowerShell
until the
Shuttle
clicks
into place. (Figure 6)
NOTE:
The
Battery
can be removed from the
PowerShell
by pressing the two blue buttons on
the
Battery Shuttle
and sliding the
Battery
out.
2. Slide the
Z1
all the way into the upper bay of the
PowerShell
until you hear a “click” sound, indicating
the
Z1
has locked into place. (Figure 7)
CAUTION:
Insert the
Z1
carefully ensuring
the power barrel connector slides into the power
input on the
Z1
.
NOTE:
The
Z1
can be removed from the
PowerShell
by pressing the two [ ] symbols on
the sides of the
PowerShell
and sliding the
Z1
out.
Figure 4
Figure 5
Figure 6
Figure 7
