32 Preparing the iSleep 20 for Use
iSleep 20 clinician’s manual
Doc. 003923 En-Us V-2
6.2 Placing the iSleep 20
6.3 Connecting the iSleep 20 to the Power Source
To Connect the iSleep 20 to the Power Source:
Read the chapter “Environmental Conditions” on page 9 carefully
to make sure all conditions are fulfilled and considered.
1
Place the iSleep 20 on a solid, flat
surface. The iSleep 20 should be
placed lower than the patient in order
to prevent the device from falling on
the patient, as well as preventing con-
densated water to reach the patient.
2
Make sure that nothing can block
the patient air inlet at the side of the
iSleep 20.
Read the chapter “Electrical Safety” on page 8 carefully to make
sure all conditions are fulfilled and considered.
1
Plug the power supply into the
power inlet of the iSleep 20.
2
Connect the power cord into the
power supply.
