Bravo EVT-4000e, Maintenance Manual

Page: 32 / 42

32
(10) CONTROLLER
Replace Controller:
(1) Release two screws on the right side trim
………………
(Picture 1)
(2) Release the connectors of controller wire harness (black
×
1
、
red
×
1
、
black 9 pin
×
1
、
white 9
pin
×
1). Release the copper nut of throttle cable and pull it out, then you can see a small
hole on the throttle pillar, put a nail through the hole so can prevent the pillar to draw back
………………
(Picture 1 & 2)
(3) Release four screws on the controller, and cut off the band to remove the
controller
………………
(Picture 1)
(4) Follow with the reversed steps to restore
＜
Tools
＞：
(1) (3) screwdriver
(Picture 1)
Two screws on the right side trim
Four screws on the controller
The throttle pillar