5.3 MAINTENANCE TO BE PERFORMED BY THE
OPERATOR
5.3.1 Hydraulic oil top up
The level of the hydraulic oil is to be checked
with the machine having
the basket lowered,
from the sight glass found under the cover.
If necessary, top up as follows:
•
Unscrew the hydraulic oil fill cap.
•
Top up with a mineral oil with a viscosity in-
dex of 22 (for climactic conditions with very
cold temperatures
that is, below
-
20°C, the use of mineral oil
with a lower freezing point , about –
45
°C, is
recommended.
•
Check and verify the oil level from the sight glass provided. If
necessary top up again.
•
Tighten down the filler cap well.
Attention
-
Pollution Hazard
Do not dispose the oil in the environment .
5.3.2 Battery Inspection and Maintenance Procedures
BEFORE PERFORMING ANY PROCEDURES ON THE BATTERIES,
disconnect the main red connector under the front cover.
Inspection Battery Terminals
If during the inspection of the battery terminal connectors on the ma-
chine, oxidation or grime build
-
up is found, proceed as follows:
•
Disconnect the terminal connectors and clean them with a rag, wet
with water. If the oxidation layer is particularly thick, brush off the top
layer and clean them with a rag wet with water.
5.2 Weight of the Machine Components
Additional Technical Information (ONLY FOR CE MACHINES):
The following information is provided in accordance with the requirements of
the European Machinery Directive 2006/42/EC and is only applicable to CE ma-
chines.
The vibration total value to which the hand
-
arm system is subjected does not
exceed 2,5m/s2. The highest root mean square value of weighted acceleration
to which the whole body is subjected does not exceed 0,5 m/s2.
As specified in the above chart, the equivalent continuous A
-
Weighted sound
pressure level at the work platform is less than 70dB(A).
Location of the serial numbers
In order to identify it, the machine has a tag on which the serial number has
been engraved. The tag is located on board the machine, on the right or left of
the column.
COMPONENT
WEIGHT
Batteries (LUI PKI)
30 kg 1pcs
264120 kg total
Batteries (LUI MINI P.A.)
21 kg
Boot Removable (LUI PKI)
12,70 kg
Boots Removable (LUI MINI P.A)
1,7 kg 1pcs
3,5 kg total
56
57
SECTION 5. GENERAL TECHNICAL SPECIFI-
CATIONS AND OPERATOR MAINTENANCE
Summary of Contents for Sprint LUI MINI P.A.
Page 25: ...48 49 SECTION 5 GENERAL TECHNICAL SPECIFI CATIONS AND OPERATOR MAINTENANCE...
Page 26: ...50 51 SECTION 5 GENERAL TECHNICAL SPECIFI CATIONS AND OPERATOR MAINTENANCE...
Page 33: ...SECTION 7 7 2 HYDRAULIC SCHEME LUI PKI 6 6 64 65...
Page 34: ...SECTION 7 7 3 HYDRAULIC SCHEME LUI MINI P A 66 67...
