Page 15
Perform all procedures listed in previous section also
4500
Cycles
Inspect platform fold axles and bearings for wear or
damage and positive securement
Inspect inner roll stop locks and torsion springs for
wear or damage and for proper operation
Inspect lower fold arm pins (2), axles (2) and
bearings (8) for wear or damage and positive
securement
Remove pump module cover and inspect:
• Hydraulic hoses,
fi
ttings and connections for wear
or leaks
• Harness cables, wires, terminals and connections
for securement or damage
• Control board, circuit breaker, power switch and
lights for securement or damage
Replace damaged parts and resecure as needed.
Apply Light Oil.
Replace damaged parts. Apply light oil to inner
roll stop lock pivot points.
Resecure, replace or correct as needed.
Resecure, replace or correct as needed.
Resecure, replace or correct as needed
Use Braun 32840-QT (Exxon
®
Univis HVI 26)
hydraulic
fl
uid (
do not mix
with Dextron III or other
hydraulic
fl
uids). Check
fl
uid level with
platform
lowered fully
and
roll stop unfolded fully
. Fill
to within 1/2” of the bottom of the 1-1/2”
fi
ll tube
(neck).
Tighten, repair or replace if needed.
Replace if needed.
Tighten or replace if needed.
Replace damaged parts and resecure as needed.
Apply Light Grease during reassembly procedures.
Replace if needed.
Tighten, replace or correct as needed
Apply Door-Ease or replace if needed. See Lubri-
cation Diagram.
Resecure or replace if needed.
Resecure, repair or replace if needed.
Check to see that the lift is securely anchored to
the vehicle and there are no loose bolts, broken
welds, or stress fractures.
Replace decals if worn, missing or illegible. Re-
place antiskid if worn or missing.
Inspect cotter pins on platform pivot pin (2)
Hydraulic Fluid (Pump) - Check level.
Note:
Fluid
should be changed if there is visible contamination.
Inspect the hydraulic system (cylinder, hoses,
fi
t-
tings, seals, etc.) for leaks if
fl
uid level is low.
Inspect cylinders,
fi
ttings and hydraulic connections
for wear, damage or leaks
Inspect parallel arms, bushings and pivot pins for
visible wear or damage
Inspect parallel arm pivot pin mounting bolts (8)
Inspect platform pivot pin, bushings and vertical
arms for wear, damage and positive securement
Inspect upper/lower fold arms, saddle, saddle
support and associated pivot pins, bushings, and
bearings for visible wear or damage
Inspect gas springs (cylinders-4) for wear or dam-
age, proper operation and positive securement
Inspect saddle bearing (1) and saddle buttons (2)
Inspect vertical arm plastic covers
Inspect power cable
Mounting
Decals and Antiskid
Maintenance and Lubrication Schedule
1500
Cycles
